![]() Select ALL the partitions on the existing C drive Run the Macrium Reflect (or Samsung Data Migration) If you are cloning from a SATA drive to PCIe/NVMe, install the relevant driver for this new NVMe/PCIe drive.ĭisconnect ALL drives except the current C and the new SSD Verify the actual used space on the current drive is significantly below the size of the new SSDĭownload and install Macrium Reflect (or Samsung Data Migration, if a Samsung SSD) Specific steps for a successful clone operation: Return the system back to original config, without the new SSD. ![]() How do I make my SSD properly launch as my boot drive? Is my windows corrupted?Īlso side note: I'm posting this an hour before I go to work so I won't be replying until tonight, thank you either way!Įither the source drive is not quite right, or you did something wrong in the clone process. I sanitized the drive using Crucial Storage Executive so my SSD is empty yet again, so it's ready to have my HDD cloned again to it but obviously I want to fix the issue before I do that. I have tried this twice and the same issued occurred both times. I then changed my boot drive back to my hard drive and windows properly launched. It automatically set itself as the boot drive which is great but whenever it tried to launch, it would bring up the "choose keyboard layout" and I'd select english, select "continue to windows 10" and it would just go back on a cycle to the choose keyboard layout. After 6 hours it was done cloning and I restarted my PC. I tried many things: disabling/re-enabling devices, uninstalling/reinstalling devices, reinstalling drivers, switching drivers, restarting services, changing BIOS settings, and rebooting many times along the way, all to no avail.I bought a crucial MX500 1TB to use as storage and to launch windows off of, so I used the Acronis True Image software that it comes with to clone my hard drive to it. The audio devices that showed up in Device Manager on the SSD were the same as on the HDD. I could even reboot and run off the old HDD and audio would work again, so I knew it wasn't a hardware issue. I had a red X over speaker icon in the system tray that said "No audio output device is installed". Everything worked when running off the SSD except audio. Not sure if you still are having problems, but I just had a similar issue after cloning my HDD to a new SSD. If you need any screenshots or additional information let me know, I will provide anything necessary. I just installed the HDD back and it boots and the audio works no problem, so it's not me ripping off the cable or anything, the problem is in software. I tried to update the chipset driver, but audio drivers already updated the chipset, and to a newer version than the standalone chipset driver. I have already googled this problem and tried everything from several sources. The audio icon in a tray is showing red circle with X in it and the popup says "No audio output device is installed". The only problem I have encountered so far is that there is no audio. The clone was done flawlessly - it boots and it boots fast. ![]() So I cloned my HDD (shows up in Device Manager as HGST HTS545032A7E3800 SCSI Disk Device) to my new SSD (Crucial BX500 480GB, MDL: CT480BX500SSD1, FW: M6CR022) using Acronis True Image for Crucial.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |